Extra break line in corridor?

I’ve built a simple 3-command corridor for some cross sections. Everything looks fine in the corridor and the plotted cross sections.

What’s strange is that the surface is adding a breakline on my 1:1 slope.

Since the corridor is small, I’ll rebuild it to see if that resolves the issue. However, I’m curious—has anyone encountered this before and found a quick fix?

The photos below show the corridor and a cross section of the surface at the same STA.


just a quick thought. If your using a 2D for your offset. Maybe that’s causing the issue.

No 2D line just a simple 12.5 LT then 1:1 tie to OG.

I recreated the corridor, and it was fine the second time. Just a WTF TBC thing.

I have not seen that - i would need to look at the data to see what it was doing - i would think there is a reason for it

Alan