Alignment profile

[Greg_Tinney]

Can I show the original ground surface in an alignment profile?
Thanks!

[Francisco_Guerrero]

Here is a post from Alan on this. Hope this helps

Overlay of Multiple Profiles

Brian If you have an alignment (if you do not have an alignment you have to create an alignment from the line you want as your reference line (you can add the line into the alignment as you create the alignment). Once you have the alignment then you can use the Create Surface Profile command to cut a profile along the alignment of any surface that you want to add into the Profile View (however that is always cut along the path of the alignment - so would not give you what you need for the EP /…

[Erik_Petersen]

You can also use create surface profile to show it as well if you already have a alignment created rather than create profile proxy.